The standard Sonex elevator trim is what we are implementing, despite all the little tweaks from the standard design, at some point you have to just stop modifying and just build the plane.
OK, a few changes but really just minor. The “swivel” at the control arm end is called out as a standard part from Asuza. It’s fine but we had modified the Bowden cable mounts on the engine and the experience with that design provided an easy modification to an AN bolt that has a more positive clamp on the cable.
We’ll have to add some detail on the design, should it be worthy of being copied.
Below are a couple photos of the design and implementation.
The control handle is basically the same as what is shown on the Sonex plans. It works well as is. The only change is the swivel.
